Title The effect of different cleaning protocols of polymer-based prosthetic materials on the behavior of human gingival fibroblasts /
Authors Rutkūnas, Vygandas ; Borusevičius, Rokas ; Liaudanskaitė, Dominyka ; Jasinskytė, Urtė ; Drukteinis, Saulius ; Bukelskienė, Virginija ; Mijiritsky, Eitan
DOI 10.3390/ijerph17217753
Full Text Download
Is Part of International journal of environmental research and public health.. Basel : MDPI. 2020, vol. 17, iss. 21, art. no. 7753, p. [1-17].. ISSN 1660-4601
Keywords [eng] polymers ; surface ; roughness ; contact angle ; fibroblasts ; proliferation ; PMMA ; PEEK ; PEKK ; cleaning
Abstract [eng] Dental implant abutment and prosthetic materials, their surface treatment, and cleaning modalities are important factors for the formation of a peri-implant soft tissue seal and long-term stability of bone around the implant. This study aimed to investigate the influence of a polymeric material surface cleaning method on the surface roughness, water contact angle, and human gingival fibroblasts (HGF) proliferation. Polymeric materials tested: two types of milled polymethylmethacrylate (PMMA-Ker and PMMA-Bre), three-dimensionally (3D) printed polymethylmethacrylate (PMMA-3D), polyetheretherketone (PEEK), and polyetherketoneketone (PEKK). Titanium (Ti) and zirconia oxide ceramics (ZrO-HT) were used as positive controls. A conventional surface cleaning protocol (CCP) was compared to a multi-step research cleaning method (RCP). Application of the RCP method allowed to reduce Sa values in all groups from 0.14–0.28 µm to 0.08–0.17 µm (p < 0.05 in PMMA-Ker and PEEK groups). Moreover, the water contact angle increased in all groups from 74–91° to 83–101° (p < 0.05 in the PEKK group), except ZrO-HT—it was reduced from 98.7 ± 4.5° to 69.9 ± 6.4° (p < 0.05). CCP resulted in higher variability of HGF viability after 48 and 72 h. RCP application led to higher HGF viability in PMMA-3D and PEKK groups after 48 h, but lower for the PMMA-Ker group (p < 0.05). After 72 h, no significant differences in HGF viability between both cleaning methods were observed. It can be concluded that the cleaning method of the polymeric materials affected surface roughness, contact angle, and HGF viability at 48 h.
Published Basel : MDPI
Type Journal article
Language English
Publication date 2020
CC license CC license description